42
4 Important Notices
Important Information about Use
Installation
• Do not use the instrument in the vicinity of a TV, radio,
stereo equipment, mobile phone, or other electric devices.
Otherwise, the instrument, TV or radio may generate noise.
• Do not expose the instrument to excessive dust or vibrations,
or extreme cold or heat (such as in direct sunlight, near a
heater, or in a car during the day) to prevent the possibility of
panel dis-guration, damage to the internal components or
unstable operation.
• The sensor of the hi-hat is exposed to extremely strong light,
it may cause error.
Power Supply
• Even when the power switch is turned o, electricity is still
owing to the product at the minimum level. When you are
not using the product for a long time, make sure to unplug
the power cord from the wall AC outlet.
Cleaning
• When cleaning the equipment, be sure to use a clean, dry
cloth. Cleaning products that contain organic solvents, paint
thinner, detergents, and chemicallytreated cleaning cloths can
cause discoloration and/or warping and should not be used.
• Do not dirty the reection plate of the hi-hat. Otherwise the
response of the instrument may get worse. When getting
dirty, clean the instrument by using a wet towel.
Data
• The company can not be held responsible for damage
caused by improper use or modications to the instrument or
data that is lost or destroyed.
• The stored contents may be lost due to malfunction of
equipment or incorrect operation. Please backup important
data.
About copyrights
• This product incorporates audio / sound data contents in
which ATV and third parties own copyrights. Using and
copying these materials without permission (except for
personal and other uses permitted by the copyright law) is
prohibited.
• ATV owns copyrights of the contents embedded or attached
to this product. Such copyrighted materials include, without
limitation, all computer software, sound / audio les, style /
image data les, etc. Any unauthorized use of such programs
and contents outside of personal use is not permitted under
relevant laws.
• Do not make, resell, redistribute, or republish the
abovementioned contents attached or aliated to the
product.
About this manual
• The illustrations as shown in this manual are for instructional
purposes only, and may appear somewhat dierent from
those on your instrument.
• The company names and product names in this manual are
the trademarks or registered trademarks of their respective
companies.
Specications
Electronic Drum Sound Module
Model: xD3
Item Specication
Terminals and Jacks
OUTPUT L/R: mono phone x2
PHONES: stereo phone
AUDIO IN: stereo mini-phone
MULTI TRIGGER INPUT: Dedicated multi connector
CRASH 2 TRIGGER INPUT: TRS phone
USB: 2.0 Type B connector (High Speed)
MIDI OUT: DIN connector
SD CARD: SD/SDHC card
DC IN: only for the included AC adapter
Power supply DC 12 V
Power consumption 600 mA
*Specications and appearance of this product are subject to change without notice for
improvement.
Support
http://products.atvcorporation.com/drums/xd3/
To Next Page
Loading...
