14 / 22
(4) Take out of the scotch tape to check if the cutting hole is exactly in the center of the nozzle
tip’s hole;
(5) Repeat all the steps above to find the best center position relative to the nozzle tips’ hole;
This is the basic method to find the best center position of laser beam.
Focus adjustment
The focus adjustment in Z axis of A230E electric fiber laser cutting head needs to be done in the
SC series cutting software showed as figure 10. User can adjust the position of focus lens unit in Z
axis step by step until to its settled position. SC series cutting software supports focus position
calibration, stepping piercing and other complicated parameters setting, which can meet different
cutting demands when cutting different metal sheet.
Figure 10. Focus adjustment of A230E on SC series cutting software.
To Next Page
Loading...