AUDAC SMA Series - PIN, LCD, and USB Functions

SMA&SMQ - User manual026
General setup >> Admin PIN
General setup >> User PIN
General setup >> LCD
General setup >> USB
General setup >> USB >> Save
In this screen the PIN of the admin can be changed. The currently selected PIN will be shown and the adjusting digit can be
selected (turns red) and conrmed by turning and pressing the rotary selection dial. Consecutive digits will increase when
the maximum value has been reached. After the desired PIN has been selected it can be conrmed by pressing (turns red)
and turning the function dial clockwise to the entire right side where the ‘OK’ word will appear. After pressing again the PIN
is conrmed.
In this screen the PIN of a user can be changed. The currently selected PIN will be shown and the adjusting digit can be
selected (turns red) and conrmed by turning and pressing the rotary selection dial. Consecutive digits will increase when
the maximum value has been reached. After the desired PIN has been selected it can be conrmed by pressing (turns red)
and turning the function dial clockwise to the entire right side where the ‘OK’ word will appear. After pressing again the PIN
is conrmed.
Adjustment for the LCD settings can be made in this screen. The brightness of the LCD can be adjusted within a range of 10%
to 100% (standard is 80%). Adjusting the LCD brightness can be convenient when the device is placed in an environment with
very low or very high ambient light. Hereby the clarity of the LCD can be adjusted in such way being clearly but unobtrusive.
The backlight off time can be adjusted within a period of never (always on) up to 120 minutes in steps of 5 minutes, making
the backlight of the LCD automatically turn off after the set time.
USB will lead you to a separate sub-menu where all settings and options using USB functions can be found. A FAT32
formatted USB ash drive should be inserted to the USB slot on the front of the amplier.
The complete conguration of the amplier can be saved to a le by using the ‘save’ button. This way, a complete backup for
system recovery can be made. This provides a great advantage for re-loading a previous conguration and duplicating the
conguration to other ampliers. A window will appear whereby the desired lename for the conguration can be selected
and the system backup will be saved as …\AUDAC\SETTINGS\FILENAME.SET