AUDAC SMA Series - USB Save and Load Configurations

SMA&SMQ - User manual 027
General setup >> USB >> Load
Different types of conguration les can be loaded into the amplier, such as loudspeaker presets (*.SPF), complete set solution
congurations (*.SOL) and system backups (*.SET). Each of the conguration les have their own letype and will be loaded
in a different way. When pressing the load button, the root folder of the USB drive is displayed. Browsing through folders is
possible through turning the rotary dial, lower folders can be easily accessed by selecting them while both top options allow
to browse up or to the root of the inserted USB drive. Additional comments about system congurations are shown on the
right side of the browse window. After the desired le has been found, it can be loaded by selecting it.
Speaker presets are les in *.SPF format which are prepared and provided by AUDAC and containing all parameters for optimal
performance and protection of the corresponding loudspeaker. When a *.SPF le is loaded, the amplier will recognize the
le type and show a popup window wherein one, none, some or all channels can be selected on which this le should be
applied (the selected output is connected to the loudspeaker). After the selected channels are selected, the ‘load settings’
option will load the *.SPF settings to the selected channels. All previously made EQ settings are removed from the selected
outputs when an *.SPF le is loaded.
Complete system congurations (set solutions) are les in *.SOL format
which are prepared and provided by AUDAC. These files contain
parameters for a complete conguration consisting of multiple (different
types of) loudspeakers, such as a combination of loudspeaker cabinets
with a bass cabinet, … These conguration les also contain information
about connected channels, bridging, ltering, etc. When a *.SOL le is
selected, it will be immediately loaded without requiring selection of the
channels where it should apply to Since this information is already included
into the *.SOL le. All previously made EQ and lter settings are removed
when an *.SOL le is loaded.
System backups are les in *.SET format. When a system backup is made
using the ‘save’ action as shown above, it will be saved as a *.SET le which can be re-loaded in similar way as a *.SOL le.
It will be immediately loaded without the user to select the outputs it should overwrite.