132 Parking systems
Adjusting the display
and the warning tones
Applies to vehicles: with advanced park ing system wit h
rear view camera/top view camera system
The display and warning tones can be adjust-
ed in the Infotainment.
.. Select : ICAR!function button> Car systems
control button > Driver assist> Parking aid.
Display
On* -
optical display is shown for the parki ng
system plus, rear view camera image is shown
for parking system plus with rear view cam-
era*.
Off - when the park ing system is switched off,
only audible signals are given.
Warning tones
Front volume -
Volume for the fro nt area
Rear volume - Volume for the rear area
Front frequency - Frequency for the front area
Rear frequency - Frequency for the rear area
Music volume while parking - When the park-
ing system is turned on, the volume of the au-
dio/v ideo source is lowered .
The newly adjusted value is briefly heard from
the signal generator .
(D Tips
- The warning tones can also be adjusted
directly from the visual display or the
rear view camera* image . Simply press
the
Settings cont rol button .
- Changed settings are activated when the
parking system is switched on again.
- The settings are automatically stored
and assigned to the remote control key
that is in use.
Error messages
App lies to vehicles: with advanced park ing system wit h
rear view camera/top view camera system
There is an error in the system if the LED in
the P•1A button is blinking and you hear a con-
t inuous alarm for a few seconds after switch -
ing on the parking system or when the park-
ing system is already activated. If the error is
not corrected before you switch off the igni-
t ion, the LED in the
P'"A button will blink the
next t ime you switch on the parking system by
shifting into reverse .
If a sensor is faulty, the!¾ symbol will appear
in front of/behind the vehicle in the Infota in-
ment display . If a rear sensor is faulty, only
obstacles that are in the front detection area
are shown . If a front sensor is fau lt y, only ob-
stacles that are in the rear area are shown.
Peripheral cameras*
There is also a system error if:
- the
'(l.Q,, symbol appears in the display and
the corresponding display area is shown in
blue. The camera is not work ing in this area.
- all segments around the vehicles are red or
if no segments are displayed.
Drive to your authorized Audi dealer or au-
thorized repair facility immediately to have
the malfunction corrected .
Trailer hitch
Applies to vehicles: wi th advanced parking syst em with
rear view camera/top view camera system
For vehicles using the trailer socket, the park-
ing system rear sensors do not turn on when
you shift into reverse gear or when you press
the
P1JA button. This results in the following re-
strictions:
There is no distance warn ing fo r the rear. The
front sensors remain activated. The visual dis-
play switches to the trailer towing mode . The
rear view camera image will not show the ori -
entation lines and the blue surfaces.
(D Tips
Trailer hitches that are not installed at the
factory may cause the parking system to
malfunction or they may restrict its func-
tion.
To Next Page
Loading...
