96 Aud i adaptive cruise control and braking guard
@ is located in front of that vehicle, the sys-
tem will not react to the stationary vehicl e.
Audi adaptive cruise
control
Description
Applies to vehicles: with Audi adaptive cruise contro l
Fig. 96 Detectio n range
What can adaptive cruise control do?
The adaptive cruise control system uses video,
radar and ultrasou nd. Moving vehicles ahead
can be recognized up to about 650 feet
(200 m) away.
On open roads with no traffic, adaptive cruise
control works like a regular cruise control sys-
tem . The stored speed is maintained . When
approaching a moving vehicle detected up
ahead, the adaptive cruise control system au-
tomatically s lows down t o match that vehi-
cle's speed and then maintains the distance
that the driver previous ly stored. As soon as
the system does not detect a vehicle up
ahead, adaptive cruise control accelerates
back up to the stored speed.
In stop-and-go traffic, adapt ive cru ise control
can brake until the vehicle stops and acceler -
ate again under certain conditions and if this
is possible within the system's limits and ca-
pabilities ¢
page 98 . Adaptive cru ise control
will not make an emergency stop .
Which functions can be controlled?
When you switch adaptive cruise contro l on,
you can set the current speed as the "control
speed" ¢
page 96, Swit ching on and off.
When driving, you can stop cruise control
¢
poge 98 or change the speed ¢ page 97
at any time .
You can also set the distance to the object
ahead and set the adaptive cruise control driv-
ing program ¢
page 98 .
Switching on and off
Applies to vehicles: with Audi adaptive cruise control
Fig. 97 Selecto r lever: switching on/off
Fig. 98 Instrume nt cluste r: adapt ive cruise cont rol
You can set any speed between 20 mph and
95 mp h (30 and 150 km/h) .
Ind icator lamps and messages in the instru -
ment cluster display inform you about the cur-
rent system status and settings .
Switching adaptive cruise control on
... Pull t he leve r toward you into position (D
¢ fig. 97 . ACC standby appears in t he in-
strument cluster display.
Setting the speed and activating
regulation
... To set the current speed, press the ISETI but-
ton ¢
fig . 97. The set speed is shown in the
tachometer @ and is also shown br iefly in
the display @ ¢
fig . 98 . ...,
To Next Page
Loading...
