134 Homelink
@ Tips
To o pen t he ga rage door, press the butto n,
but do not press it for longer ten seco nds
or the Homelink modu le will switch to
programming mode.
Programming transmitters
Applies to vehicles: with Home link
Fig. 152 Left front area of the bumper
You can prog ram both fixed code a nd rolling
code systems using these instructions .
Programming a button
> Make su re your ve hicle is wit hin opera t ing
range of t he remo t e con t rolle d garage door
opener .
> Set the parki ng brake¢ .&. in General infor-
mation on page 133.
> Switch the ign ition on. Do not st art the en-
gine!
> There are two ways to program a button:
press the button that you wou ld like to pro-
gram . The MMI will display instruct ions to
guide you t hroug h the programm ing. Or
> Se lect : I CAR I fu nction butt on> Car systems
cont rol butt on > Vehicle settings > Garage
door opener
> Program garage door open-
er.
.. Se lect the button t hat you wo uld like to pro-
gram.
.. Follow the instructions in the MMI.
• If the garage door open ing must a lso be
synchronized wit h the Homelink mod ule,
refer to t he owner's manual fo r the ga rage
doo r ope ner.
Erasing the button programming
> Sele ct: I CAR I function butto n > Car systems
fu nction key > Vehicle setting s> Garage
door opener
> Clear program settings >
Yes.
Displaying the version/status/country
code
.. Select: I CAR I function button > Car systems
cont rol button > Vehicle settings > Garage
door opener > Version information .
Programming a button
The requir ed dist a nce between th e hand held
t ransmit t er and t he Homel ink modu le in t he
bumpe r depe nds on the system that you are
programming . When programm ing a new de-
vice, keep the button pressed for at least 15
seconds before trying aga in with the transm it-
te r in a diffe rent position .
Each of the buttons can be reprogrammed in-
dividua lly. The procedure is the same as for in-
itial programm ing .
c> page 134 , Programming
a button .
Erasing the button programming
Individual buttons can be reprogrammed . Fol-
low the same steps used when first program-
ming the button.
If you would like to erase all prog rammed but -
tons at the same time, select Erase butto n
programming.
(D Tips
- To ens ure your sa fet y, e ras ing t he pro-
gramme d Home li nk buttons before sell-
ing the vehicle is recommende d.
- Depending on the model of t he gara ge
door opener, you may need to release t he
button on the rem ote and press it again
when programming .
To Next Page
Loading...
