(D Note
- Always follow the manufacturer's in-
structions for all electrical accessories
you want to use with the electrical sock-
et!
- Do not connect lamps that contain a ne-
on tube. For technical reasons the lamp
may be damaged .
- Do not connect any 230-volt equipment
to the 115-volt socket . The equipment
may be damaged . If necessary, check the
permissible voltage for the equipmen t
on the mode l label.
- In the case of some power packs , e.g. for
a laptop computer, the built-in overcur-
rent shutoff prevents it from be ing
swit ched on because of excessive start-
up current. In th is case, disco nnect t he
power pack from the consumer and re-
connect it after about 10 seconds.
(I) Tips
- Unshielded equipment may cause inter-
ference in the radio and the vehicle elec-
tronics.
- Some eq uipment may work properly be-
cause of the reduced power (wattage),
available from the socket.
Folding table in the center console
Applies to vehicles: with fold ing table in the center con·
sole
The folding table is stored in the front area of
the center console .
Fig. 66 Rear center console: opening the folding table
S ea t s a n d s t o rage 69
Fig. 67 Rear cente r console : folding table inclined po·
sition
Opening
.,. Pull the handle @ back ¢ fig. 66. The fold -
ing table extends out partially by itself
~.&.-
.. Pull the folding table up unti l it locks into
place @ .
.. Fold the t able t op back and down
©-
Storing
.. Release the tabletop @ to fold it back.
.. You can now move the folding tabl e vert ical-
ly back into its original position.
A WARNING
- Do not open the folding tab le while driv-
ing. Opening the folding table while driv-
ing increases the risk of injury in the
event of a collision or sudden brak ing .
- To reduce the risk of pinching, open and
close the folding table carefully and in a
contro lled manner .
To Next Page
Loading...
