A ss is tance s y s tem s
- For safety reasons, active lane assist must
not be used when there are poor road and/
or weather cond itions such as slippery
roads, fog, gravel, heavy rain, snow and the
potent ial for hydroplaning. Using active lane
assist under these conditions may increase
the risk of a crash .
Switching on/off
Applies to: veh icles with Audi active lane assist
•
Fig. 11 4 Turn signal lever: butto n for active lane ass ist
Fig. 11 5 Winds hield : came ra window for act ive lane ass ist
"' Press the button to switch the system on and
off <=>
fig. 114 . The . or . indicator light in
the instr ument cluster turns on or off .
Indicator light s
• Ready: the indicator light turns on when the
system is ready for use. The system can now be
operated .
• Not ready: the indicator light turns on if the
system is switched on but is inoperab le. This may
be due to the following reasons:
- There is no lane marker line.
- The relevant lane marker lines are not detected
(fo r example , mark ings in a construction zone
104
or because they are obstru cted by snow, dirt,
water or lighting).
- The vehicle speed is below the activation speed
of approximate ly 40 mph (65 km/h).
- The lane is too narrow or too wide.
- The curve is too narrow.
- The driver's hands are not on the steering
wheel.
@ Tips
Make sure the camera's field of view
<=>
fig. 115 is not obst ructed by sticke rs or any-
thing else. For information on cleaning, see
<=>page 306 .
Image in the instrument cluster display
Applies to: vehicles with Audi active lane assist
Fig. 11 6 Inst rumen t cluster: act ive lane assist is switched
on and provid ing warn ings
Fig. 1 1 7 Ins trume nt clust er: act ive lane ass ist is switched
on but not ready to provide warn ings
You can call up the active lane assist display us-
ing the buttons in the mu ltifunction steering
whee l ¢ page 12. .,..
To Next Page
Loading...
