Audi A8 2018 - Towing with a Tow Truck

- When connecting jumper cables, make sure
that they cannot get caught in any mov ing
parts in the engine compartment.
- Before you check anything in the engine
compartment, always read and heed a ll
WARNINGS
¢ page 272.
(D Note
Impro per hook-u p of jum per cables can ru in
the generato r.
- Always connect POSITIVE( +) to POSITIVE
(+), and NEGATIVE(- ) to NEGATIVE(- )
ground post of the battery manager contro l
unit.
- Check that a ll screw plugs on the battery
cells are sc rewed in firmly . If not, t ighten
plugs p rior to connect ing clamp on negative
batte ry te rmi nal.
- Please note t hat the procedure fo r con nect-
ing a jumper cab le as desc ribed above ap-
plies specifica lly t o t he case of your vehicle
being ju m p starte d . When you are g iving a
ju mp star t t o ano t her vehicle, do
not con-
nect th e neg ative( -) ca ble to the neg at ive
(-) t ermin al on t he disch arged bat te ry @
¢ fig . 290. Instead, securely connect the
negat ive(- ) cab le to either a solid metal
component that is f irm ly bolted to the en-
gine block or to the engine bloc k itself. If
the battery that is be ing charged does not
vent to the outs ide, escap ing batte ry gas
could ignite and explod e !
Towing with a tow truck
General hints
Your Audi requires special handling for towing .
The fo llowing informa t ion is t o be used by com-
mercia l tow tr uck opera t ors who know how to op -
e rat e the ir equip men t safely.
- Never tow your Audi. Towing will cause dam-
age to the engine and transmission.
- Never wrap the safety chains or winch cables
~ around the brake lines.
....
~ - To prevent unnecessary damage, your Audi
N
8 must be transported with a flatbed truck.
0
:c
'<I"
Emergency situations
- To load the vehicle on to the flatbed, use the
towing loop found in the vehicle tools and at-
tach to the front or rear anchorage
¢ page 329 and c> page 330.
A WARNING
A veh icle being towed is not safe for passen-
ge rs. Never allow a nyo ne to ride in a vehicl e
being towed, fo r any reason.
Front towing loop
Fig. 291 Fron t bu m pe r: removing the cap
Fig. 292 Fron t bu mpe r: insta lling the tow ing loop
The thread for the towing loop is on the right
s ide of the front bumper beh ind a cap.
.,. Remove the towing loo p from the vehicle too l
kit.
.,. Press the cap inward with brief, forceful pres-
sure
c> fig. 291 . The cap will loosen from the
bumper.
.,. Tigh t en the tow ing loop in the t hreaded open -
ing until it stops
c> fig. 292 and t hen t ighten it
wit h a wheel wre nch .
.,. Afte r using, place th e t ow ing loop back in the
veh icle tool kit .
IJJ>-
329