Audi connect
Audi connect
Introduction
Applies to: vehicles with Audi connect
With Audi connect services, online information is
transmitted and integrated direct ly in the vehi-
cle.
A mobi le end dev ice can be used to access the In-
ternet through a Wi- Fi hotspot, either when the
vehicle is stationary or from the rear seat when
the vehicle is in motion.
A separate Aud i connect SIM card prov ided by
Audi connect is used to access Audi connect se rv-
ices .
A WARNING
- To reduce the risk of an accident, on ly use
Audi connect serv ices when road and traff ic
condit ions permit. Read and follow the
guidelines prov ided in c:>
page 135 .
- Use the Audi connect serv ices w ith a Wi-Fi
hotspot only in the rear seat when the veh i-
cle is in mot ion or only when the vehicle is
stationary to reduce the risk of an acc ident .
@ Note
Audi connect is designed for use only with the
prov ided Audi SIM card. Audi AG is not liable
for the consequences of using other SIM
cards.
(D Tips
Read and follow the notes about Audi con-
nect before start ing it
c:>page 163 .
Setup
Requirements for Audi connect
An Internet connection is required to use Audi
connect. The following requirements must be
met to establish a connection:
- You m ust be in an area that is covered by your
provider.
- Your Audi SIM card must be inserted in the
MMI SIM card reader
c:>page 158.
158
-
- A data connection must be configured for Audi
connect services
c:> page 162.
Using the SIM card reader
Appli es to: vehicles wit h Audi connect
Audi multimedia
Fig. 174 Insert ing the Audi SIM card, actual size of t he
Audi SIM card
Requirements
The vehicle must be stationary and the ignition
must be sw itched on.
Inserting the Audi SIM card
~
....
:c
..
a:
.,. Slide the Aud i SIM card into the card reader
slot with the label fac ing up (contact surface
facing down)
c:> fig . 174 . The angled corner of
the Audi SIM card must be at the left front cor-
ner. Then push the Audi SIM ca rd into the slot
until it clicks into place .
.,. To connect to t he Internet automat ically in the
future, select and then confirm Yes.
.,. To establish a data connection for Audi con -
nect, confirm the message that appears wit h
Yes.
After connecting successfully
After conn ectin g successfully, the signa l strength
is indicated in the In fotainment display status ..,.
To Next Page
Loading...
