lL
t:0
....
"'
......
"'
....
0
0
:c
'<I"
could start the engine or operate electrical
equipment such as power windows.
(D Tips
- The operation of the remote control key can
be temporarily disrupted by interference
from transmitters in the vicinity of the vehi-
cle work ing in the same frequency range
(such as a cell phone or radio equipment).
- Using the mechanical key, you can:
- Locking/unlocking the glove compartment
,;:;,page 64.
- Manually lock/unlock the vehicle
,;:;,page 32.
- Mechanically lock the doors c:> page 32.
- Unlock the luggage compartment lid us-
ing the emergency release
r;;:;, page 36.
- For an explanation on conformity with the
FCC regulations in the United States and the
Industry Canada regulations, see
r;;:;,page 339 .
(D Tips
Removing the integrated mechanical key
Fig. 21 Remote control maste r key: remov ing the mechani-
cal key
.,. Press the release button @ r;;:;, fig. 21 .
.,. Pull the mechan ical key @ out of the remote
control key.
Opening and closing
LED and battery in the remote control key
Fig. 22 Remote control key: removing the battery holder
LED on the remote control key
The LED @ informs you about the function of the
remote control key.
.. If you press a button briefly, the LED blinks
once.
.. If the LED does not blink, the remote contro l
key battery is dead. The
ml indicator light and
the message
Please change key battery ap-
pear . Replace the battery in the remote control
key.
Replacing the remote control key battery
.. Remove the mechanical key r;;:;, page 29 .
.. Press the release button ® on the battery
holder and pull the battery holder out of the re -
mote control key in the direct ion of the arrow
at the same time .
.,. Insert the new battery with the"+" symbol fac -
ing down .
.,. Slide the battery holder carefully into the re-
mote contro l key .
.. Insert the mechanical key.
@ For the sake of the environment
Discharged batteries must be disposed of us-
ing methods that will not harm the environ-
ment. Do not dispose of them in household
trash.
{!) Tips
The replacement battery must meet the same
spec ificat ions as the origina l battery in the re-
mote control key .
29