Audi Q4 e-tron 2024 - Page 125

89A0127218G.
High-voltage system
Power frequency 50 Hz/60 Hz
Overvoltage category (IEC 60664) [II
Short-time current rating (EN <10 kA eff.
61439-1)
Power plug versions
5-15
NEMA 6-30; NEMA 6-50; NEMA 14-30; NEMA 14-50; NEMA
Integrated residual-current device
Vehicle charging connector Type
AC: 20 mA; DC: 56 mA
Protection class 1
IP Code 55 (USA: Enclosure 3)
Control unit mass 5.3 lbs - 7.7 lbs (2.4 - 3.5 kg)
Control unit dimensions (height x
width x depth)
12.2 inx 4.1 in x 2.8 in (310 mm x 105 mm x 72 mm)
~The device runs a self test after power has
been restored to the control unit. Ifa self
testis successful, all indicator lights will il-
luminate green for two seconds.
~The Audi e-tron Charging System Compact is
designed for charging at sockets with a volt-
age of 120 V/240 V. If your socket has a dif-
ferent voltage, contact and authorized Audi
dealer or authorized Audi Service Facility.
— If your Audi e-tron Charging System Com-
pact has a fixed connection, meaning it can
be connected directly to the power supply
without a power cable, contact a qualified
electrician or an authorized Audi dealer or
authorized Audi Service Facility.
~The system complies with United States FCC
regulations and ISED regulations
= page 291.
Changing or attaching the cable
Applies to: vehicles with Audi charging system
Fig. 89 Control unit: removing and attaching the cable
Requirements:
» The charging process for the high-voltage bat-
tery must be ended page 109.
» The vehicle charging connector must be re-
moved from the vehicle charging port.
» The power cable must be removed from the
socket.
Loosening the cable
> Lift the lever @) alll the way up.
» Pull the connector @) out just until you feel re-
sistance.
» Close the lever @ until it is resting on the con-
nector @).
» Remove the connector @) completely.
Attaching the cable
» Lift the lever @ up slightly.
123
OwnersManuals2.com