Audi Q4 e-tron 2024 - Software Update

Additional settings
selected. If Invisible is selected, a Bluetooth con-
nection will only be possible with paired devices.
If Off is selected, no Bluetooth device can be con-
nected.
Bluetooth® audio player
When this function is switched on, the profile
will load automatically when your Bluetooth au-
dio player is within range.
Bluetooth® name
The MMI’s Bluetooth name is displayed and can
be changed.
The name of the Wi-Fi hotspot and the Blue-
tooth name are automatically compared
when there are changes.
Factory default settings
» Applies to MMI: Select on the home screen:
SETTINGS > System maintenance > Restore
factory settings.
» Follow the system instructions.
The settings will be reset. The system will re-
start. This may take some time.
Make sure that not only the settings were de-
leted but also the stored data, if applicable.
Software update
Introduction
Applies to: vehicles with software update
You can update your vehicle's software.
The functions depend on the country and vehicle
equipment:
— Update through the online system update |)
© page 226.
~ Map material update for the navigation system
= page 201.
1) The function or equipment that is described was in devel-
‘opment at the time this manual was published and may
‘not be available in your vehicle.
226
— Have the software update performed by an au-
thorized Audi dealer or authorized Audi Service
Facility. This can result in additional costs.
—Perform the installation only when the vehi-
cle is stationary. Otherwise, this increases
the risk of an accident
— If the installation fails, contact an author-
ized Audi dealer or authorized Audi Service
Facility immediately to have the malfunc-
tion corrected.
Online system update")
Applies to: vehicles with online system update
With the online system update, you can update
the software directly in the vehicle.
Requirement: the MMI must be connected to the
Internet > page 185, Audi connect. you must be
logged in to your myAudi account in the vehicle.
Downloading updates
Online system updates are downloaded automat-
ically and without prior notice, and will resume if
necessary once the ignition is turned on again. A
message will be displayed in the center screen af-
ter the download is complete.
Installing updates
Requirement: an online system update must be
downloaded and a notification must be shown in
the center display.
» Stop the vehicle safely.
» Switch the emergency flashers off, if necessary
» Make sure that the 12 volt vehicle battery is
charged.
» Make sure that the high-voltage battery is not
being charged and that no charging connector
is connected to the charging port.
» Press on the notification, or
» Open the notification in the notification center
‘on page 23 and press on the notification.
» Follow the system instructions. >
OwnersManuals2.com