Audi Q4 e-tron 2024 - Page 149

8901272186
Driver assistance
@ The marked band shows if the vehicle speed
is planned to drop below the set speed due to
the road layout.
Overriding control
You can override the predictive control at any
time by pressing the accelerator pedal. If the sys-
tem changes the vehicle speed to adapt to speed
limits, you can change the speed using the lever
> page 143, fig. 106.
Messages
Ifa message with Predictive control is displayed
when there is a malfunction, the functions are
unavailable or limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors ® page 132 and try to turn on the sys-
tems again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Facili-
ty immediately to have the malfunction correct-
ed.
= Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 129 to > page 132.
— Pay attention to traffic and the area around
your vehicle when predictive control is
switched on. The driver is always responsible
for assessing the traffic situation.
~The system does not consider “right of way”
rules and does not respond to traffic lights,
so lack of driver attention in these situations
can increase the risk of an accident.
~The speed when driving through curves may
be different from what you as a driver would
do or may not be suitable for the weather
and road conditions. If necessary, apply the
brakes and reduce the selected speed to be
maintained in the Adjustment to curves
D Incertain countries.
along route setting to reduce the risk of an
accident.
— Predictive control can exceed or drop below
the maximum permitted speed. The driver
is always responsible for adhering to the
permitted speed limits.
~The traffic signs on the road always take pri-
ority over the display. The driver is always
responsible for adhering to the regulations
applicable in the country where the vehicle
is being operated.
— If a speed limit is detected, the marking @
© page 142 of the set speed limit will be ad-
justed even if the adaptive cruise assist is
not actively regulating.
~ You may temporarily fall below or exceed
the set speed due to recuperation.
- Control by the system depends on which
adaptive cruise assist driving program is set
or on the selected Audi drive select* mode.
— After switching on the ignition and first
driving onto a freeway or similar road with-
out a speed limit, the system will regulate
the speed to 80 mph (130 km/h)”. Then
the system adjusts to the last speed set by
the driver.
— There is no adaptation to speed limits when
driving through highway interchanges and
when driving on or off the expressway.
— The system can fail to provide control or the
control may be faulty if the values from the
camera-based traffic sign recognition* are
incorrect or the navigation system* map da-
tais outdated.
—When route guidance is switched on, the
system adapts to the route provided by the
navigation system. Driving without route
guidance or leaving a route can result in
faulty control.
147
OwnersManuals2.com