Audi Q4 e-tron 2024 - Page 273

8901272186
Emergency assistance
Removing the caps
.
Fig. 164 Wheel: wheel bolts with caps
» Slide the plastic clip from the vehicle tool kit
onto the cap until it engages © fig. 164.
» Remove the cap with the plastic clip.
osening the wheel bolts
» Slide the wheel wrench* onto the wheel bolt as
far
as it will go.
» Turn the wheel bolt approximately one turn to
the left to loosen it.
To reduce the risk of an accident, only loosen
the wheel bolts gently one turn before raising
the vehicle with the vehicle jack*.
Fig. 165 Sill panels: markings
» Place the vehicle jack* on a firm surface. Use a
flat, stable support if necessary. Ona slippery
surface such as tile, you should use a non-slip
pad such as a rubber mat > A\.
» Find the marking on the sill that is closest to.
the tire that will be changed © fig. 165. Behind
the marking, there is a lifting point on the side
sill for the vehicle jack".
» Lift the vehicle using the vehicle jack* until the
wheel lifts off the ground slightly.
To reduce the risk of injury, make sure no
one is in the vehicle before raising it.
— Make sure the vehicle jack* is stable. The
risk of injury is increased when the ground is
slippery or soft, because the vehicle jack
could slide or sink.
— Position the vehicle jack* only at the desig-
nated mounting points on the side sill and
align the jack. Otherwise, the vehicle jack*
could slip and cause an injury if it does not
have sufficient hold on the vehicle.
To reduce the risk of an accident, never start
the drive system when the vehicle is raised.
—To reduce the risk of injury, no work should
be performed under the vehicle while it is
raised.
Do not lift the vehicle by the sill. Position the
vehicle jack only at the designated mounting
points on the side sill. Otherwise, your vehicle
could be damaged.
Removing and installing a wheel
Removing a wheel
» Remove the loosened wheel bolts completely
using the wheel wrench* and place them on a
clean surface.
» Remove the wheel >@.
Installing a wheel
Read the directions on * page 272 when instal-
ling unidirectional tires.
» Install the wheel.
» Install the wheel bolts and tighten them light-
ly.
» Carefully lower the vehicle using the vehicle
jack*.
» Tighten the wheel bolts in a diagonal pattern
using the wheel wrench*.
271
OwnersManuals2.com