Audi Q4 e-tron 2024 - Page 48

Opening and closing
These functions are operated in the MMI. Multi-
ple receivers can be programmed, which can con-
trol the functions of up to eight") hand-held
transmitters.
— When operating or programming the garage
door opener, make sure that no people or
objects are in the area immediately sur-
rounding the equipment. People can be in-
jured or property can be damaged if struck
when closing.
— Do not allow yourself to be distracted from
traffic by viewing and operating the center
display.
~ If you sell your vehicle, reset all settings to
the factory default settings > page 226.
~The system complies with United States FCC
regulations and ISED regulations
page 291.
Before you program your system to the ga-
rage door opener, first check the compatibili-
ty:
— Ask an authorized Audi dealer or authorized
Audi Service Facility or check at www.
homelink.com. You can also find more infor-
mation about HomeLink there.
— You can display information about Home-
Link (compatibility level/status/country
code/HomeLink generation) in the MMI:
— Select on the home screen: VEHICLE > Set-
tings & Service > Garage opener > @.
‘Applies to: vehicles with garage door opener
Requirements: the remote control transmitter
must be programmed © page 46, Program-
ming, the vehicle must be within range of the
system, and the ignition must be switched on.
1) The possible number of hand-held transmitters depends
on the equipment.
46
There are multiple options to open or close the
system (such as the garage door).
» To display the -@ button (Garage opener) for
the garage door opener, press the =] button in
the status bar > page 23.
» If you have only programmed one remote con-
trol transmitter, press the -@ button in the sta-
tus bar on the center display > page 27. Or
» If you have programmed multiple remote con-
trol transmitters, press the -@ button in the
status bar on the center display > page 27 and
then press the button for the respective sys-
tem. Or
» Applies to: vehicles with programmable steer-
ing wheel button: If you have configured the
programmable steering wheel button, press
the *K button © page 30. Or
> Applies to: vehicles with GPS pairing: If you
have programmed Location pairing, press the
respective button in the center display (notifi-
cation center © page 23). As you approach the
system, the button is displayed on the MMI. Or
» When reverse gear is selected, the parking sys-
tem* / rearview camera* / peripheral camera*
will appear in the center display. To display the
buttons of the first three garage door openers,
press the =] button in the status bar and then
press the button for the respective system.
If transmission was successful, the message:
Send to: XXX will appear.
Applies to: vehicles with garage door opener
You can program both fixed code and rolling code
systems in the MMI using the procedure that is
described.
Requirement: the ignition must be switched on.
Programming the system
Applies to: MMI
Requirement: the hand transmitter must be
present and the vehicle must be within range of
the system (such as the garage door) that you = >
OwnersManuals2.com