Audi Q4 e-tron 2024 - Page 66

Sitting correctly and safely
~The upper edge of the head restraint is as even
as possible with the top of your head.
~The head restraint is as close as possible to the
back of the head.
~The head restraints in any occupied rear seats
are all the way up.
—There is one head restraint for each seat. All
vehicle occupants must adjust the head re-
straints correctly before every trip. Having
head restraints that are not adjusted cor-
rectly or not installed in the vehicle increas-
es the risk of a neck injury during sudden or
unexpected driving or braking maneuvers or
ina collision.
— Only remove the rear seat head restraints if
it is necessary to install a child safety seat
page 73. Stow the removed head re-
straints securely, for example in the luggage
compartment. Reinstall the head restraints
immediately once the child safety seat has
been removed. Driving without head re-
straints increases the risk of serious neck in-
juries.
Front head restraints
Applies to: vehicles with adjustable head restraints
Fig. 55 Front seat: adjusting the head restraint
The settings depend on the vehicle equipment.
Adjusting the head restraints
» To adjust the head restraint upward, down-
ward, or backward, press the button on the side
and slide the head restraint. Release the button
and slide the head restraint farther until it
locks into place.
64
» To adjust the head restraint to the front, slide it
until it locks into place.
Rear head restraints
Applies to: vehicles with adjustable head restraints
Fig. 56 Rear seat: adjusting or removing the head restraint
Adjusting the head restraints
» To adjust the head restraint upward, slide it un-
til it locks into place.
» To adjust the head restraint downward, press
the button @ and slide the head restraint. Re-
lease the button and slide the head restraint
farther until it locks into place.
Removing the head restraints
Applies to: vehicles with removable head restraints
> Fold the backrest forward slightly > page 82.
> Move the head restraint upward all the way.
» Press the button @) © fig. 56. If the head re-
straint is equipped with another button, then
also press that button (@). Pull the head re-
straint out of the backrest at the same time
= A\ in General information on page 64.
Installing the head restraints
» Fold the backrest forward slightly + page 82.
» Slide the posts on the head restraint down into
the guides until the posts click into place.
» Press the button @) and slide the head restraint
all the way down. It should not be possible to
remove the head restraint from the backrest
without pressing the button.
OwnersManuals2.com