______________________________________________________ H_o_m __ e_L_i_n_k_@_R _ __.11111
10. Press and hold the trained Homelink® button and
observe the indicator light © ==>
page 142, fig . 153.
- If the indicator light is solid/cont inuous, programming is
complete and your device should activate when you
press and release the trained Homelink® button .
- If the indicator light blinks rapidly for 2 seconds and is
then a solid/continuous light, proceed with phase 3 to
program a rolling code device.
Ph a s e 3: roll ing c o de pr og ra mmin g
- A second person on a ladder who can safe ly reach the
garage door opener motor is recommended.
11. Locate the "learn" button on the garage door opener
motor (refer to the operating instructions for the opener,
as the location of this button may
vary by manufacturer).
12. Press and release the learn button on the garage door
opener motor .
- Note : once the button is pressed, there are 30 second s in
which to init iate the next step .
13. On t he Homelink® keypad inside the vehicle, firmly
press and hold the HomeLink® button previously
programmed in phases 1 and 2 for two seconds and
release . Repeat this sequence
twi ce.
Some vehicles may require the press/hold/re lease
sequence up to three times to complete the training
process.
- Homelink® should now activate your rolling code
equipped device.
Cont rols and equip-
ment
If the 5 minute time limit is exceeded, the emergency flashers
will
flash one time to indicate that the process has been terminated. In
this case, repeat steps 4 through 9.
If the emergency flashers do not flash
three times (after about 15-
60 seconds), programming was not successful. In this case, repeat
steps 4 through 9.
Remote con t rol units for garage door openers in Canada are set to
stop transmitting radio frequency signals after two seconds. This
time may not be sufficient for the Homelink® system to learn the
radio frequency signal. Perform all other steps as described
above . •
App li es to vehicles: with Home l ink® universa l remote con tro l
Operating the Homelink ® transmitter
The HomeLink® transmitter works in the same manner as
the original hand held remote control that came with the
system.
11111
Fig. 155 Overhead
console: Home li nk®
keypad
- Press the appropri ate programmed button 0 , © or @
to act ivate the des ir ed remote con t rol function
==> & in
"Gene ral information" on
page 147. •
Vehicle care
I I
irechnical data
To Next Page
Loading...
