Audi TT 2007 - Page 95

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove noise insulation (left-side) -arrows-.
– Remove bolts -arrows- and detach cover for gear oil pump
-A-, allowing remaining gear oil in cover to drain off into used
oil collection and extraction unit -V.A.G 1782- .
– Remove bolts -arrows- and detach cover for gear oil pump
-1-.
Installing
• Tightening torques ⇒ page 80 , ⇒ page 82
Installation is carried out in reverse sequence; note the following:
Note
♦ Renew bolts for gear oil pump and for cover for gear oil pump.
♦ Renew gasket -B- and cover for gear oil pump.
– Check that dowel sleeves -C- are fitted in gearbox housing.
– Slide drive shaft -A- for gear oil pump into gearbox as far as
stop, turning shaft slightly as required.
Audi TT 2007 ➤
Direct shift gearbox 02E, front-wheel drive - Edition 12.2006
1. Oil pan, mechatronic unit, gear oil pump - exploded view 91