@ Tips
- Do not reset the display between oil
changes, otherw ise the display will be in-
correct.
- The information in the Service Reminder
remains stored even when the vehicle
battery is disconnected.
Lap timer
Introduction
Applies to vehicles : wit h lap timer
You can record and evaluate lap times wit h
the lap timer in the display
c:> page 27,
fig. 22. The time is measured in minutes, sec-
onds and 1/10 seconds. The hours are also
shown when the lap time exceeds 60 minutes.
The maximum individual measurement is 99
hours.
A WARNING
-
Please devote your full attent ion to driv-
ing. As the driv er, you have comp lete re-
sponsibility for safety in traffic. Only use
t he f unct ions in such a way that you always
maint ain complete contro l over your vehi-
cle in all traff ic situ at ions.
@ Tips
W hen the lap t imer stopwatch is running,
you can call up the t rip computer info rma-
t ion wit h the
I RESET I button .
Calling up the lap timer and timing
Applies to vehicles: wit h lap timer
------- @
Fig. 21 Contro ls
Dr iv er in f ormation system 2 7
Fig. 22 Display: Lap timer
Calling up the lap t imer
.. Press the I RESET I q fig. 21 @ button until
the lap timer
q fig. 22 appears.
Timing laps
.. To start timing, press the upper section of
the wiper switch @ . The time measurement
is shown in line
CD Q fig. 22.
.. To stop timing, press the upper section of
the wiper switch @ again. This also starts
timing the next round . The previous t ime
moves one line up, first to line @ and the n
t o line @ . Line @ shows the current lap
number, for example LAP 5.
Displaying intermediate time and pausing
timing
.. To display an intermediate time, press t he
lower section of the w iper swit ch @ . The in-
t ermediate t ime appears in line
CD and is
marked with* .
.. To pause t iming, press the lower section of
the wiper switch @ again .
.. To continue tim ing, press the upper section
of the wiper switch @ .
If timing is paused, you can continue it later
even if you switch the ignition off.
To Next Page
Loading...
