7 4 On the road
Speed warning 2: setting a speed limit
Switches in the wiper arm are used to operate
warning threshold
2 .
'----I ®
Fig. 73 Wiper lever: Trip computer controls
To store maximum speed
>Turnoff the ignition.
> Briefly press the button in the instrument
cluster ¢
page 73, fig. 72. The odometer
and the digital clock are now illuminated .
> Press the button for at least 2 seconds . The
currently stored maximum speed appears in
the display or the crossed out symbol for
warning threshold 2, if no max imum speed
was set previously.
> Press the function selector sw itch in the
wipe r lever @ ¢ fig. 73 up or down to
change the set value. Values run up or dow n
in steps of 6.2 mph (10 km/h).
To delete maximum speed
>Turnoff the ignit ion.
> Briefly press the button in the instrument
cluster ¢
page 73, fig. 72. The odometer
and the digital clock are now illumi nated.
> Press the button fo r at least 2 seconds . The
cu rrently stored maxim um speed appears in
the display.
> Press the reset button in the wiper lever ®
¢ fig . 73 until the crossed out speed warn-
ing symbol for warning threshold 2 appears
in the display.
A few seconds after the adjustment is com-
pleted, the illumination for the odometer and
the dig ital clock will go out.
(D Tips
This warning threshold can also be con-
trolled thro ugh the tr ip computer
¢ page 23, Navigating the menu.
Cruise control
Switching the system on
The cruise control system makes it possible to
drive at a constant speed starting at 20 mph
(30 km/h) .
®-
Fig. 7 4 Cont rol lever with set button
Fig. 7 5 Display : Selecte d speed
> Pull the lever to position (D ¢ fig. 74 to
switch the system on.
> Drive at the speed you wish to set.
> Press button @ to set that speed.
..,
....
i
The display ¢ fig. 75 will show the set speed .
The display may vary depending on the type of
display in your vehicle. The indicator light
M;ll)~14 (US model)/ . (Canadian model) will
also light up in the instrument cluster .
A WARNING
- Always pay attent ion to traffic even when
the cruise control is switched on. You are
always responsib le for your speed and
To Next Page
Loading...
