The speed warning system has two warning
thresholds
that function independently of
each other and that have somewhat different
purposes:
Speed warning 1
You can use speed warn ing 1 to set the maxi-
mum speed while you are driving. This setting
will remain in effect until you turn
off the igni -
tion, assuming that you have not changed or
reset the setting.
The speed warning symbo l
(mj (USA models)/
(SJ (Canada mode ls) in the warning 1 display
appears when you exceed the maximum
speed.
It goes out when the speed falls below
the stored maximum speed.
The speed warning symbo l wi ll also go out if
the speed exceeds the stored maximum speed
by more than about 2S mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted.
Setting speed warning l <=:> page
73.
Speed warning 2
Storing warning 2 is recommended if you al-
ways want to be reminded of a certa in speed,
for example when you are traveling in a coun-
try that has a general maximum speed limit,
or if you do not want to exceed a specified
speed for winter tires.
The speed warning 2 symbol,
(zj <USA mod-
els)/
(•j (Canada models) appears in the dis-
play when you exceed the stored speed lim it.
Unlike warning 1, it will not go out until the
vehicle speed drops below the stored speed
limit .
Sett ing speed warning 2 <=:>page 74.
@ Tips
Even though your vehicle is equipped with
a speed warning system, you should sti ll
watch the speedometer to make sure you
are not driving faster than the speed lim it.
On the road 73
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the button.
Fig. 72 Section of instrument clust er: Set/Check but·
ton
Storing the maximum speed
.,. Drive at the desired maximum speed .
.,. Press the knob button r=:>fig . 72 unti l the
speed warning symbol
[fl (USA models)/ ~
(Canada models) appears.
Resetting the maximum speed
.,. Drive the vehicle at a speed of at least
3 mph (5 km/h)
.,. Press the knob for more than 2 seconds.
The speed warning symbol
(Zl (USA models)/
i•j rcanada models) will appear briefly in the
display when you release the button to indi-
cate that the maximum speed has been stored
successfully .
The maximum speed remains stored until it is
changed by pressing the button again briefly
or until it is deleted by a lengthy push on the
button.
To Next Page
Loading...
