EasyManua.ls Logo

Audi TT 2014 - Page 61

Audi TT 2014
252 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When should the roof rack be removed?
- Before going through an automatic car wash
(it is best to ask the car wash operator for
advice).
- When not in use, to reduce fuel consump-
tion, wind noise and to guard against theft.
_& WARNING
- Use of an unapproved roof rack or incor-
rect mount ing of an approved roof rack
can cause the roof rack or the items at-
tached to it to fall off the roof onto the
road .
- Objects falling from the roof of a vehicle
can cause a crash and personal injury .
- Only mount the system between the
markings shown in
¢ page 59, fig. 61.
- The roof rack system must be installed
exactly according to the instructions pro-
vided.
(D Note
- Your vehicle warranty does not cover any
damages to the vehicle caused by using
roof racks or mount ing structures not
approved by Audi for your vehicle. The
same applies to damage resulting from
incorrect roof rack installation.
- Always check the roof rack mountings
and hardware before each t rip and dur-
ing a tr ip to make sure everything is se-
curely tightened.
If necessary, retighten
the mount ings and check the ent ire sys-
tem from time to time.
- After mounting a roof rack system, or
whe n you transport objects on the roof
of your vehicle, the height of the vehicle
is naturally increased. Be careful when
driving under low br idges or in parking
garages for example. This could cause
damage to the load and even the vehicle
itself .
Seats and storage 59
Mounting locations
The roof rack must be attached only at the
positioning bolts.
Fig. 61 Mounting locat ions for roof rack
Installation
When installing the feet make sure that they
are pos itioned exact ly on the positioning bolts
provided @ between the side panel and the
upper roof frame ¢
fig. 61. The positioning
bolt is visible as soon as the lip of the sealing
strip is pushed back from the roof frame with
the tool provided.
Loading the roof rack
Always distribute the loads evenly. Make sure
anything on the roof rack is securely tied
down.
.,. Always distribute the loads on the roof rack
even ly.
.,. Always attach items to the roof rack securely
before you drive off.
The maximum permissible roof weight is
165 lb (75 kg). The roof weight is made up of
the weight of the roof rack system and the
weight of the object being transported.
When using a roof rack system which has a
lower load carrying capacity, you must not use
up the total maximum permissible load carry-
ing capacity specified above. Instead, you
should load the roof rack system only to the
maximum capacity spec ified by the manufac-
turer of the roof rack system . ..,.

Table of Contents

Related product manuals