EasyManua.ls Logo

Audi TT 2014 - Page 89

Audi TT 2014
252 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
may not be sufficient for t he Homelink sys -
tem to learn the radio frequency signal. Per-
form all other steps as descr ibed above .
Operating the Homelink transmitter
The HomeLink transmitter works in the same
manner as the original hand held remote con-
trol that came with the system.
Fig. 89 Overhead conso le: Home lin k keypad
Press the app ropriate programmed button
©, @ o r @ to activat e t he des ired remot e
co ntrol func tion
¢ &. in General informa-
tion on page 85.
Reprogramming a single button
A HomeLink button can be reprogrammed in-
dividually without affecting the other butt on
allocati ons.
Programming the overhead keypad
Press the app ropriate Homel ink button u n-
t il t he indicato r light begins flas hing slowly.
Programming the bumper mounted trans
mitter
1. Hold the original remote control at a dis-
tance between
0- 5 in. (0- 13 cm) from the
bumper be low the appropriate headlight
fo r you r vehi cle (use the shortest dist an ce
possib le).
2. Aim the remote cont rol just below the
driver side head light.
3. Press and hold t he activation button on
the remote contro l.
4 . The emergency flas hers will flash
three
times
(afte r about 15- 60 seconds) when
Homelink 8 7
t he programming is successful. Now re-
lease the button on t he remote control.
If the dev ice utilizes a rolling code, please
follow phase 3 of ¢
page 85, Programming
the Home Link transmi tter
for rolling code
prog ram ming .
This procedure will cause the existing pro-
gramming on the Homelink button to be
erased!
Erasing the programming of the
Homelink transmitter
When you erase the programming, the pro-
gramming on all three of the transmitter
channels with be lost!
Perform steps 1 to 4 as described on
¢ page 86, Phase 1: programming the over-
head keypad .
When completed, t he Homelink system will
be in the prog ramm ing mode and is then
ready to learn the codes fo r re mot e controlled
devices.
(D Tips
- Programmed buttons can not be erased
ind ivid ually.
- For security reas ons you are advis ed to
erase t he progra m ming of th e Homeli nk
syst e m before yo u se ll you r vehicle.

Table of Contents

Related product manuals