38
•
Load default
With this function you can reset all the parameters in the various menus (fig. 14, at page
46).
You can use the remote control for this function.
•
Set link
In the case in which several AUDIA units are connected in link mode, with the function
“SET LINK” you can define the role of the present unit, if “Master” or “Slave”, namely, if
the present unit will provide to send the command codes (Master) or if it must receive
them (Slave, fig. 13 at page 46).
You can use the remote control for this function
•
Software version
With this indication you may read the software version used to manage the operation of
your AUDIA Flight One.
To Next Page
Loading...
