Audient EVO 4 User Manual

INSTALLATION / SETUP
EVO 4 will require drivers on Windows so that the computer and EVO 4
will work together. You can download these from the downloads page
on the EVO 4 page.
Once downloaded, run the .exe le to start the installation process.
Follow the instructions on screen to complete the installer. This process
may take a little while so please be patient.
INSTALLATION / SETUP WINDOWS
Once complete, click nish. Now carefully unpack your EVO 4 and
connect it to the computer using the included USB cable.
To set the EVO 4 as your default sound device, go to Control Panel >
Hardware and Sound > Sound. Now select the Playback tab.
In the list of devices, nd EVO 4 Main Output 1+2, click on it and select
Set Default Device.
For more advanced settings such as changing your sample rate or
buer size, please read the Software features section, found later in
this manual.
Control Panel > Hardware and Sound > Sound

Audient EVO 4 Specifications

General

Type	Audio Interface
Number of Preamps	2
Bit Depth	24-bit
Bus Powered	Yes
Direct Monitoring	Yes
Loopback	Yes
Phantom Power	48V
Sample Rate	96 kHz
Inputs	2 x XLR/TRS Combo
Outputs	2 x TRS
Simultaneous I/O	4 in / 4 out
USB	USB-C
Driver	Class Compliant