ATW-R1810 Single-channel Receiver Controls (front panel)
Liquid Crystal Display shows battery status and frequency settings.
BNC-type antenna connectors. Attach the antennas to the antenna input jacks. Make certain that
during operation there is a clear open-air path between the receiver antennas and the
transmitter.
True Diversity operation: two antennas feed two completely independent RF sections on the
same frequency; automatic logic circuitry selects the superior signal.
Diversity Indicators A and B show which tuner has the better reception and is in operation.
Turns the unit on and off. Use with the Up/Down arrows to choose operating frequencies
manually or automatically (using your choice of three automatic scan groups).
Indicates when the unit is on. Also indicates receiver overload by turning off; too much signal will
cause blinking LED (off during peaks). To correct overload, adjust audio gain on transmitter.
(
See Audio Input Level (Gain) Adjustments on your transmitter, page 12.
)
Press Up or Down arrows, in conjunction with the Power/Set button, to choose operating
frequencies manually or automatically (using your choice of three automatic scan groups).
LCD
Antenna Input Jacks
Diversity Indicators
Power / Set Button
Power/Peak LED
Up/Down Arrows
1
2
3
4
5
6
2
3
6
1
2
5
4
6
E
N
OM 1800 Series single (Nov.08).qxd:Layout 1 27/11/08 16:25 Page 6
To Next Page
Loading...
Need help?
General
