AudioCodes MediaPack MP-118 Fast Track Guide

MediaPack
Analog Fast Track Guide 24 Document #: LTRT-59802
3.4.4 Example of Connecting Two MP-118 Devices
This example applies to H.323 and SIP. Figure 3-6 below shows an example of two MP-118/FXS
devices’ internal routing tables. The phone ‘2001’ is connected to the first channel of gateway
10.2.222.108, and phone ‘2101’ is connected to the first channel of gateway 10.2.222.107.
To make a call between two gateways, lift the receiver of phone ‘2001’; you hear a dial tone and
the first Channel Status LED lights up. Dial 2101; after dialing the last digit phone ‘2101’ rings.
Note 1: The prefixes you choose in the ‘Tel to IP Routing’ table must differentiate the
gateways from each other to ensure correct routing. In the example, using the
first digit (2) doesn’t differentiate the devices, thus 2 digits of the phone
number are used.
Note 2: To enable phones connected to the same MediaPack to communicate with
each other, define in the internal routing table the IP address and
corresponding phone numbers of the device itself.
Figure 3-6: Example of Connecting Two MP-118 Devices

AudioCodes MediaPack MP-118 Specifications

General

Category	Gateway
Analog Ports	8 FXS ports
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Protocols	SIP, MGCP, H.323
Model	AudioCodes MediaPack MP-118
Fax Support	T.38
Management	Web-based, SNMP, CLI
Security	SRTP, TLS, HTTPS
Power Supply	AC 100-240V, 50-60Hz
Humidity	10% to 90%, non-condensing
Network Interfaces	2 x 10/100Base-T Ethernet