AUMA ACE C 01.2 Profinet Series - Safety Instructions; Basic Safety Information

Read operation instructions first.
●
Observe safety instructions.
Purpose of the document:
This document contains information for the commissioning staff of the distributed control system and DCS software
engineers.This document is intended to support actuator integration into the DCS via the communication interface.
Reference documents:
●
Operation instructions (Assembly, operation, commissioning) for actuator
●
Manual (Operation and setting) AC 01.2 actuator controls Profinet
Reference documents can be downloaded from the Internet (www.auma.com) or ordered directly from AUMA
(refer to <Addresses>).
Table of contents Page
41. Safety instructions.................................................................................................................
41.1. Basic information on safety
41.2. Range of application
51.3. Warnings and notes
51.4. References and symbols
62. General information on Profinet...........................................................................................
62.1. Basic characteristics
72.2. Profinet basic functions
72.3. Communication technology
72.4. Bus access
72.5. Topology – Profinet device network configuration
92.6. Profinet communication cable
102.7. Profinet conformance classes
112.8. Supported functionality
112.9. Protective functions
112.10. Device types
123. Commissioning......................................................................................................................
123.1. Introduction
123.2. Profinet addressing – device name assignment
133.3. Configuration of Profinet interface
133.4. Communication start
133.5. Communication monitoring
133.5.1. Communication monitoring of Profinet communication
133.5.2. Communication status
143.6. I & M functions
154. Description of the data interface..........................................................................................
154.1. Input data (process representation input) – signals
154.1.1. Process representation input (default process representation)
174.1.2. Description of the bytes in the process representation input
304.2. Output data (process representation output)
304.2.1. Process representation output arrangement
324.2.2. Description of the output data
374.3. Profinet services
374.4. Redundancy
2
Actuator controls
Table of contents AC 01.2/ACExC 01.2 Profinet