Actuator Types
Control Versions of Integral Starter Units
Auma e-pac
Power Supply Module consists of
Relay Module consists of
Auma e-pac
The electronic version of Auma India Integral
Starter e-pac incorporates sophisticated
electronic controls with field programming
feature. E-pac is modular in construction and
consists of Power Supply Module, Relay
Module & Programmable Control Module.
Reversing contactors electrically and
Selector switch LOCAL-OFF-REMOTE,
lockable & potential free contacts for local-
Push buttons OPEN-STOP-CLOSE for
Single phase supply for space heater 10W
24 V DC, 150 mA source
mechanically interlocked
off & remote
local controls
Monitor relay for collective fault
signals (Thermo switch trip, torque switch
trip in mid travel) with potential free contacts
Local status annunciation (Green) & fault
annunciation (Red) by LEDs
Programmable Control Logic Module consists
of
Inching & Non-inching in local mode by dip
Inching & Non-inching in remote mode by dip
Limit switch seating or Torque seating by dip
switches
switches
switches
Wide varieties of versions of e-pac & optional
features make the actuator controls adaptable to
any field situation. Versions & optionals
For detailed literature, refer separate catalogue.
available are :
23
Emergency shut down (ESD)
2 wire make-break
Timer board to run the actuator in ON-OFF
Wall mountable e-pac
Positioner with PID features
Thermal overload relay
Remote annunciation relays
Automatic phase correction
Single phase protection
or without isolator
Electronic positioner for regulating duty, with
Remote control & local stop
Negative switching
Open-Close inhibit
steps
To Next Page
Loading...
