auna iTuner 320 BT - Getting Started; Basic Operation and Initial Setup

48
EN
GETTING STARTED
This instruction manual explains the basic instruction for operating this
unit. Unless otherwise stated, all operations described are based on remote
control use.
Powering ON/OFF
1. Press the Volume/ dial on the unit or the  button on the remote
control to switch the unit on.
2. Press the Volume/ dial on the unit or the  button on the remote
control to switch the unit back to standby mode.
Selecting Modes
Press MODE button on unit or remote control to access Mode Menu. Turn
the SCROLL&SELECT dial on unit or press
⏮ / ⏭ buttons on remote control
to select, then press SCROLL&SELECT dial on unit or SELECT button on
remote control to switch between Internet radio, Podcasts, Spotify, Music
Player, DAB Radio, FM Radio, BT Audio and AUX In modes.
When the unit is idle for approximately 15 minutes, it will automatically
switch to standby. To switch the unit o completely, remove the mains plug
from the main socket. Turn the unit o completely to save energy when not
in use.
Adjusting the Volume
• Turn the VOLUME/ dial on the unit or press the VOL +/– buttons on
the remote control to adjust the volume.
• If you wish to turn the sound o, press the MUTE button on the remote
control. Press the MUTE button again or turn VOLUME/ dial on the
unit or press the VOL +/– buttons on the remote control to resume
normal listening.
Navigating the Menu
1. Press and hold the MENU/INFO button on the unit or press the MENU
button on the remote control to access the menu.
2. Turn the SCROLL&SELECT dial on the unit or press the
buttons on the remote control to select your choice.
3. Press the SCROLL&SELECT on the unit or SELECT button on the remote
control to conrm your selection.
Initial Set-Up
When you rst connect the unit to the mains socket, the display will
show the welcome screen then with language menu shown up, turn