USING HEADPHONES
Do not listen to music at high volume when using headphones. Doing so
can cause permanent hearing impairment. Turn the tuner volume level to
the lowest before using headphones.
• Only use headphones with a 3.5-mm jack plug.
• Insert the headphone connector in the headphone socket in front of the
unit.
Long-term exposure to loud music may cause hearing damage. It is best
to avoid extreme volume when using earphones, especially for extended
periods of time.
SLEEP SETTING
This function allows you to program the unit to turn to standby mode by
itself after a set period of time.
1. To activate the sleep function, press the SLEEP button repeatedly. The
time will change in the below sequence on every press:
2. When your desired sleep time appears in the display, stop pressing the
button and the sleep function will be activated in two seconds. “ ” will
show on the display. Also the time remaining until switch o is displayed
next to the symbol in the display.
3. When the sleep timer counts down to zero, the unit will turn to standby
mode. To turn the sleep function o while the sleep timer is still counting
down, press the SLEEP button repeatedly to select “SLEEP OFF”.
Alternatively:
1. Press the MENU button on the remote control to display the function
main menu. Press the
buttons to select Main menu, and then
press the SELECT button to conrm.
2. Press the buttons to select Sleep mode, and then press the
SELECT button to conrm.
3. Press the buttons to select sleep timer, and then press the
SELECT button to conrm.
Sleep OFF
15 minutes
30 minutes
45 minutes
60 minutes
To Next Page
Loading...
Need help?
General
