auna iTuner 320 BT - Setting the Alarm; Alarm Configuration and Control

69
EN
SETTING THE ALARM
Setting the Alarm
1. Press the ALARM button on the remote control, the display shows
“Alarm (1 or 2): O [hh:mm]”.
2. Press the
buttons to select the Alarm number (1 or 2)
and then press the SELECT button to start thesetting of the following
parameters.
Press the buttons to select then press the SELECT button to
conrm.
Enable O/ Daily/ Once/ Weekends/ Weekdays
Time (Alarm On time)
Mode Buzzer/ Internet radio/ Spotify/ DAB/ FM
Preset Last Listened/ (Preset station)
Volume Muted, 1-32
Save Save and conrm the alarm setting
3. Finally, select “Save” and press the SELECT button to save the alarm
setting. When the alarm is set, the alarm icon will appear on the display
during standby mode.
4. To temporarily switch o alarm, press the SNOOZE button on remote
control to activate Snooze function when alarm sounds. Press the
SNOOZE button on remote control repeatedly to set snooze period time
of 5, 10, 15 or 30 minutes in turn. The set snooze time will show on the
display and unit will go to standby.
5. To turn o the alarm when it sounds, press the VOLUME/ dial on the
unit or the  or ALARM button on the remote control.
Cancelling the Alarm
1. Press the ALARM button on the remote control, the display shows
“Alarm (1 or 2): On [hh:mm]”.
2. Press the
buttons to select the Alarm number (1 or 2) and
then press SELECT to start the setting of the timer.
3. Press the buttons to select “Enable” then press the SELECT
button to confirm.
4. Press the buttons to select “Off” then press the SELECT
button to confirm.
5. Finally, select “Save” and press the SELECT button to save the setting.
6. Alternatively, during Standby mode, press the ALARM button on remote
control repeatedly can turn the saved Alarm 1/2 on/o sequentially.
If no button is pressed within approx. 15 seconds, the unit exits timer setting
mode automatically.