auna iTuner 320 BT - FM Operation; FM Station Tuning and Display Information

64
EN
FM OPERATION
Press MODE button on unit or remote control to access Mode Menu. Turn
the SCROLL&SELECT dial on unit or press ⏮/⏭ buttons on remote control
to select FM Radio mode, then press SCROLL&SELECT dial on unit or
SELECT button on remote control to conrm.
The display will show the frequency
Auto Scan
Press SCAN button on unit or remote control to start searching for a station.
Once a station has been found, the scanning will stop automatically.
Alternatively, press and hold
buttons to start searching for a
station.
Note: The search may not stop at a station with a very week signal.
Manual Tuning
To search for FM stations manually, turn the SCROLL&SELECT dial on unit
or press the
buttons on remote control repeatedly until your
desired frequency is reached.
Note: With FM radio, it may be necessary to ne tune each station by
turning the SCROLL&SELECT dial on unit or pressing
buttons
on remote control repeatedly. Each press will adjust the frequency by
0.05MHz. If reception is still poor, adjust the position of the aerial or try
moving the radio to another location.
FM Display Modes
Every time you press the MENU/INFO button on unit or INFO button on
remote control , the display will show the following display modes: Radio
Text – Programme Type – Frequency – Date
RDS Radio
Text
This is a scrolling message information about the
current programme.
Programme
Type
This describes the “Style” or “Genre” of music that is
being broadcast.
Station
Name /
Frequency
When an RDS station is received, the name of that
station will be displayed, or if not the frequency will
bedisplayed.
Date This displays the current date provided automatically by
the broadcaster.
FM
radio
FM Radi o