50
EN
Pin (code number)
The radio generates an 8-digit code number. Enter this code number into
the wireless router or access device.
Connecting using your wireless network password
If your router has not got a WPS button you will now be asked to enter your
wireless network password, or you can select SKIP WPS which also take you
to the password screen.
1. Press
buttons to select each letter/number of your
password. Then press SELECT button to enter the selected letter/
number.
2. When you have entered your password, press buttons to
select OK on the right of the screen.
3. After your radio has connected, press SELECT button to exit the setup.
Settings can be changed at any time in Menu-System Settings - Network -
Network wizard: This instruction manual explains the basic instruction for
operating this unit. Unless otherwise stated, all operations described are
based on remote control use.
To Next Page
Loading...
Need help?
General
