AURATON 2020 - Support of the AURATON 2020 TX Plus controller

3. Using the pushbuttons set a new
communication code in the range from 1 to 255
and acknowledge it by pressing RETURN.
4. The yellow diode " " of the AURATON 2020
RX Plus receiver should blink several times
which means that the new code is recorded.
5. If the changed code gives no improvement of
the communication between the AURATON
2020 TX Plus controller and AURATON 2020
RX Plus receiver the code should be changed
again.
17. Support of the AURATON 2020
TX Plus controller
The set is includes a plastic support of the
AURATON 2020 TX Plus controller.
AURATON 2020 TX Plus - Support
52
EN