auronic AU3265 - Changing the Dust Bag; Maintenance and Cleaning; Voice Notifications

70
4.2 Voice notications
If the robot is malfunctioning, red ashes or stays on continuously and a voice notication
sounds. Follow the instructions given in the voice notication to resolve the fault.
If the above method does not resolve the problem, try the following:
1. Press the reset button with a needle.
2. Restart the robot.
3. If the problem cannot be resolved, contact our customer service department.
5. MAINTENANCE AND CLEANING
ATTENTION!
◊ Always turn off and unplug the robot before cleaning to avoid malfunctions and electric
shock.
◊ Regular maintenance and effective cleaning are recommended.
◊ Do not use abrasive or harsh cleaning agents, or solvents such as thinners, solvents,
acetone, etc. to clean the robot. Use only clean water.
◊ If the water tank/dust collector and/or lter are full of dust or dirty, suction may be
weakened.
◊ Clean the water tank/dust collector with water and allow it to dry completely before using it
again.
◊ If the shape of the lter is distorted or does not match the lter cover, replace it.
◊ If you have washed the lter with water, dry it for at least 24 hours in a well-ventilated area
in the shade. It may give off a strange odor if the water has not been completely removed.
◊ After cleaning the water tank/dust collector, empty the remaining water and open the
rubber stopper to remove the water.
5.1 Changing the dust bag
If the indicator light on the dust collection/charging station is continuously red, it means that
the dust bag is full. The dust bag should then be replaced. It is recommended to change the
dust bag every 4 weeks.
1. Open the cover of the dust collection station.
2. Remove the full dust bag.
3. Throw away the full dust bag.
4. Place a new dust bag in the dust collection station and close the lid.
5. The dust collection station is again ready for use.