auronic AU3265 - Battery; Charging; Instructions for Use

52
otherwise the product will not charge correctly.
• Do not press the charging terminals with your hands; never use loaded objects to contact
the charging terminals, this may cause injury.
2.5 Battery
• If the battery leaks, avoid contact with skin, eyes, open skin or wounds. Wear gloves. In case
of accidental exposure to battery uid, ush affected areas with plenty of clean water and
seek medical attention immediately. Remove dead batteries/batteries from the product
immediately, as there is an increased risk of acid leakage.
• If the battery leaks, contact your local council or household waste collection service for
information on how best to dispose of it.
• Do not break or disassemble the battery.
• Always check the battery for signs of damage or leaks before using the product. Do not
charge a damaged or leaking battery pack.
• The charging station is designed for a specic voltage. Always check that the mains voltage
matches the voltage on the rating plate.
• Do not throw the battery into a re. Do not attempt to crush, puncture or otherwise
disassemble the battery pack for any reason.
• Remove the battery pack from the product before disposing of the product.
• Keep the battery pack away from open ames. Do not short-circuit the battery pack.
• Fully charge the product before using it for the rst time. This may take a few hours.
• Do not expose the battery pack to high temperatures or excessive heat.
• Do not heat the battery pack or place it near a heat source.
• Do not charge the battery pack with any type of charger other than the charging station
provided with the product.
• Do not use a damaged charging station.
• Fully charge the battery pack at least once a month to prevent battery damage.
3. INSTRUCTIONS FOR USE
3.1 Charging
The instructions below apply if you want to operate the robot using the control buttons on the
robot. You can also operate the robot using the app. See the instructions at 3.9.
ATTENTION!
◊ Make sure that there is no water in the water reservoir when charging the robot.
◊ Never touch the charging points of the charging station and robot with your hand or a
loaded object, and never apply pressure to the charging points. This may cause personal
injury.
◊ Do not install the charging station in a damp place or in a place that places it in direct
sunlight.
1. Place the charging station on a at surface, close to the wall and near an electrical outlet.
Make sure there are no objects within 1.2 meters in front of the charging station and within
0.5 meters to the sides.