Programming successful.
Sensor ID, PSN, Pressure,
Temperature, Frequency and
Voltage are displayed on the
screen.
By using Copy by OBD, the sensor ID that is retrieved from TPMS ECU is
programmed to the new MX-Sensor. There is no need to perform the Relearn
function to write the ID into the ECU when the new programmed sensor has
been put in the same position. The Copy by OBD programming method, if
available, is recommended to program new MX-Sensors as there is no need
for Relearn.
Copy by Activation
This function is used to activate the original sensor and retrieve the ID of the
sensor, and then program the original sensor ID to the new MX-Sensor.
To Next Page
Loading...
