Autocruise 2012 Van Conversion Range - Page 90

equipment details
88
The use of naked flames is prohibited
in petrol station environments. If the
refuelling stop lasts longer than 15 mins
the refrigerator should be switched off at
the main switch (A), or switched over to
another energy type.
Gas faults at ‘AUTO’ mode
If gas faults occur the operating LED ‘C’
flashes yellow.
A
C
Remedies:
Set the energy selector switch (A) to
position ‘OFF’.
1. Is there any gas in the gas bottle?
2. Is the gas bottle valve open?
3. Is the on-board shut-off valve open?
4. Set the main switch (A) to ‘on’.
The ignition starts again.
If after about 30 seconds the operating display
(C) starts flashing red again, the gas fault has
not been cleared (e.g. air in the gas pipe).
5. Briefly switch the refrigerator off and then
on again using main switch (A).
To remove air from the gas pipes, repeat
this procedure 3-4 times.
If these actions do not help, please call an
authorised Dometic Service Centre.
Additional functions
(RM 7XX5 L - models only)
• Temperaturesettingdisplay(D)with4
LED to indicate the selected temperature
(MIN-MAX)
• LED-dimmer(E)foradjustingthe
brightness of the display-LED (only
accessible when door opens)
E
D
E
Underneath the fascia is a knurled knob for
adjusting the brightness (see item E above).
Temperature setting cooling compartment
As shown, you are able to regulate the
temperature of the cooling compartment, if
necessary, by turning rotary knob (B).
The cooling unit’s performance is influenced by
ambient temperatures.
B
Medium
setting
Tip: Please select the medium setting for
ambient temperatures between +15°C and
+25°C. The unit operates within its
optimum performance range.
refrigerators