Autocruise 2012 Van Conversion Range - Page 97

equipment details
95
- do not switch on any electrical devices
orlighting;
-openthewindowsandleavetheroom;
- contact the Customer Service
department of Thetford.
•Yoususpectaleakinthecoolingsystem:
-switchofftherefrigerator;
-extinguishanynakedames;
-providesufcientventilation;
- contact the Customer Service
department of Thetford.
ABOUT YOUR REFRIGERATOR
Your refrigerator has a cold space and a
freezercompartment.Afterstartingupthe
refrigerator, allow it to cool for at least eight
hours before placing any food in it.
Cold space
The cooling fins are located on the inside of
your refrigerator. The absorption system uses
the cooling fins to withdraw heat from the
refrigerator. Therefore, never place plastic or
paper over the cooling fins. Air must be able to
circulate freely through the refrigerator so that
heat can be extracted.
Important! Do not cover the cooling fins at
the back of the refrigerator with plastic or
paper. The refrigerator cools optimally when
air is allowed to move freely through the
refrigerator.
•Tolimitfrostingonthecoolingns:
- always cover liquid foods before placing them
intherefrigerator;
- always let hot food cool before placing it in
therefrigerator;
- never keep the refrigerator open longer than
necessary.
Fitting racks
Inside your refrigerator there are two or three
storage racks. You can adjust the racks to a
convenient height by means of a simple click
system:
•clicktheplasticbrackettotherightshortside
oftherack;
•turnthebracketintothehorizontalposition
and insert the rack tipped in a sloping
positionintotherefrigerator;
•placetheshortsidewithoutbracketinto
one of the grooves on the left wall of the
refrigerator;
•placetheshortsidewithbracketinthe
corresponding groove on the right wall of
therefrigerator;
•turnthebracketdownwardstoxitintothe
groove.
To move a rack, turn the bracket upwards and
remove the rack. Place the rack at the required
height in the way described above.
Securing products for driving
The fitting racks in your refrigerator have
a system for you to secure products while
driving. The system consists of a simple click-
and-slide plastic strip. To secure products on
the rack while driving, push the plastic strip
as tightly as you can against the products on
the rack. In the storage space on the inside
of the refrigerator door, there are two unique
Thetford bottle slides (see illustration) The
slides prevent bottles from sliding around
during driving. Push the slide against the
products in the door or place the products
between the bottle slide .
Freezer compartment
Important!
-Thefreezercompartmentisunsuitableas
ameansoffreezingfood,thefreezerwill
maintainthetemperatureofalreadyfrozen
food