Autocruise 2012 Van Conversion Range - Page 98

equipment details
96
- Use only drinking water to make ice cubes.
- Do not place any other products in the
freezercompartmentwhenyouaremaking
ice cubes.
-Waterfreezesfastestwiththethermostatat
the highest setting.
Tip!
- Make ice cubes at night when your
refrigerator has more spare capacity.
Door locking mechanism
The refrigerator door has an automatic locking
mechanism. The door locks automatically
when you press it shut firmly. This automatic
locking mechanism also keeps the refrigerator
door shut during driving. For some models an
additional security device is fitted below the
refrigerator. By pushing the locking bar over
the pin when the door is closed, you can be
sure that the door does not open during your
journey.
If you are not going to use the refrigerator
for a prolonged period of time, you can use
the special storage latch of the door locking
mechanism (see illustration) to prevent odours.
Rotate the hook through 90 degrees and lock
it in place using the strike plate.
MODEL NUMBERS:
Electrical ignition N80E
•EES(ElectricEnergySelection):the‘Electric’
version, where the preferred energy source
has to be selected manually [no ‘Auto’
function possible]
SWITCHING ON THE REFRIGERATOR
(control panel)
•Itisrecommendedtocleantheinsideofthe
refrigerator before you switch it on.
•Lettherefrigeratorcoolforatleasteight
hours before you place food in it for the first
time.
Switching on the refrigerator
A = Main switch (on/off)
B = Mode selection switch
C = cooling level selection switch
D = Function LED
E = LCD display
1. Open the valve of the gas bottle.
2. Open the taps of the gas supply.
3. Press main switch (A). The function LED will
turn blue and all symbols on the LCD display
will light up.
4. Use the mode selection switch to select
the power supply that you want. The LCD
display will show the option you have
selected.
5. Set the desired refrigerating cooling level by
means of the cooling level selection switch
(C). The LCD display will show the cooling
level setting you have selected.
A. Use the main switch to switch the
refrigerator on and off. The function LED
will turn blue. The display LCD shows the
most recent settings. After 10 seconds the
LCD display’s backlight will go out. The
function LED remains blue.
B. Press the mode selector switch and the LCD
display backlight will show the setting for 10
seconds. Pressing the mode selector switch
successive times takes you through the
menu in the following sequence: Manual
DC (12V), manual gas, manual mains
voltage (230V).
refrigerators