EasyManua.ls Logo

AutoGyro Calidus - Page 71

AutoGyro Calidus
185 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Pilot Operating Handbook
Calidus
SECTION 4
NORMAL PROCEDURES
AutoGyro_POH_Calidus Revision 4.0 Issue Date 17.JAN.2019 4-2
The following checks must be carried out before each flight. However, if the gyroplane is
operated by a single pilot or within an organization where the checks are performed by or
under the supervision of qualified personnel, check list items marked with a preceding ʘ
may be carried out daily, before the first flight of the day.
Before exterior check
ʘ Fuel tank drain(s)................................................................................... Sample
ʘ Snow/ ice (if any)................................................................................ Removed
Documents ............................................................................... Check complete
Exterior check
Station 1 (engine, RH side)
Open RH access door
ʘ Before turning prop: MAG switches ................................................. Check OFF
ʘ Engine oil level ........................................................................................ Check
ʘ Dip stick and oil cap............................................................ Installed and secure
ʘ Coolant level............................................................................................ Check
Close RH access door
Oil cooler and hoses RH........................................ Clean, no leaks, fittings tight
Exhaust system RH............................................................................No cracks
Engine cowling RH ................................. Properly installed, all fasteners locked
External generator ...........................................Secure, V-belt in good condition
Station 2 (stabilizer)
ʘ Stabilizer general condition...................................................................... Check
Stabilizer attachment ............................................................................... Check
Rudder control cable linkage ................................................................... Check
Upper rudder bearing................................................ Secure, no excessive play
Rotor blades condition and cleanliness.................................................... Check
Blade tips .................................................................................................. Tight

Table of Contents