C2-2040(HS)-GigE Camera Hardware Reference Manual Rev. 1.8 • 73
Pin/Wire
No.
Wire Colour Signal Name Description
17 White/Gray GND Reference ground for IO and Laser signals
(Note when using the C2 pigtail cable: I/O signals are not isolated. The maximum voltage level is
limited to 5 V. The outputs are not capable of load driving)
IMPORTANT NOTE: When using C2 power & I/O cables (standard or pigtail) with length longer than
20 m it is recommended to supply the camera with a voltage of 24 V
To Next Page
Loading...
