C2-2040(HS)-GigE Camera Hardware Reference Manual Rev. 1.8 • 23
Name Rev. Interface Access Description
each packet for this stream channel
UserSetControl
Name Rev. Interface Access Description
UserSetSelector 1.2 IEnumeration R/W Selects the feature User Set to load, save or
configure:
- Factory
- UserSet1
- UserSet2
- UserSet3
UserSetLoad[UserSetSelector] 1.2 ICommand W Loads the User Set specified by UserSetSelector to
the device and makes it active.
UserSetSave[UserSetSelector] 1.2 ICommand W Saves the selected User Set specified by
UserSetSelector to persistent memory.
UserSetDefaultSelector 1.2 IEnumeration R/W Selects the feature User set to load at power up:
- Factory
- UserSet1
- UserSet2
- UserSet3
ChunkDataControl
Name Rev. Interface Access Description
ChunkModeActive 1.2 IBoolean R/W Enables the chunk data mode.
ChunkModeSelector 1.2 IEnumeration R/W Selects the chunk data mode:
- OneChunkPerFrame
- OneChunkPerProfile
EventControl
Name Rev. Interface Access Description
EventSelector 1.2 IEnumeration R/W Selector for the Event to control:
- AcquisitionStart
- AcquisitionEnd
- TransferStart
- TransferEnd
- AoiTrackingOn
- AoiTrackingOff
- AoiSearchFailed
- AutoStarted
EventNotification 1.2 IEnumeration R/W Notification type to issue when selected event
occurs:
- Off
- GigEVisionEvent
FileAccessControl
Name Rev. Interface Access Description
FileSelector 1.2 IEnumeration R/W Selects the target file in the device.:
- UserSetDefault
- UserSet1
- UserSet2
- UserSet3
- UserData
- ColStatisticBits
FileOperationSelector 1.2 IEnumeration R/W Selects the target operation for the selected file in the
device. This Operation is executed when the
FileOperationExecute feature is called:
- Open
- Close
- Read
- Write
FileOperationExecute 1.2 ICommand W Executes the operation selected by
FileOperationSelector on the selected file.
FileOpenMode 1.2 IEnumeration R/W Selects the access mode in which a file is opened in
the device.
- Read
- Write
To Next Page
Loading...
