Chapter 5: DURAPULSE MODBUS Communications
5–6
Presets Parameters
P5.00
Jog 0500 41281 2400
P5.01
Multi-Speed 1 0501 41282 2401
P5.02
Multi-Speed 2 0502 41283 2402
P5.03
Multi-Speed 3 0503 41284 2403
P5.04
Multi-Speed 4 0504 41285 2404
P5.05
Multi-Speed 5 0505 41286 2405
P5.06
Multi-Speed 6 0506 41287 2406
P5.07
Multi-Speed 7 0507 41288 2407
P5.08
Multi-Speed 8 0508 41289 2410
P5.09
Multi-Speed 9 0509 41290 2411
P5.10
Multi-Speed 10 050A 41291 2412
P5.11
Multi-Speed 11 050B 41292 2413
P5.12
Multi-Speed 12 050C 41293 2414
P5.13
Multi-Speed 13 050D 41294 2415
P5.14
Multi-Speed 14 050E 41295 2416
P5.15
Multi-Speed 15 050F 41296 2417
* For Modbus Decimal addresses used with CLICK PLCs,
insert another zero as the next-to-most-significant digit, e.g., 402333 instead of 42333.
** Some parameters are available only in later firmware versions of DURAPULSE drives.
Refer to P9.39 and “DURA
PULSE Parameter Summary” in Chapter 4 for more information.
Parameter can be set during RUN Mode.
Parameter Memory Addresses (continued)
Parameter Description Hexadecimal
Modbus
Decimal *
Octal
Analog Parameters
P4.00
Source of Frequency Command 0400 41025 2000
P4.01
Analog Input Offset Polarity 0401 41026 2001
P4.02
Analog Input Offset 0402 41027 2002
P4.03
Analog Input Gain 0403 41028 2003
P4.04
Analog Input Reverse Motion Enable 0404 41029 2004
P4.05
Loss of AI2 Signal (4-20 mA) 0405 41030 2005
P4.11
Analog Output Signal 040B 41036 2013
P4.12
Analog Output Gain 040C 41037 2014
P4.13**
2nd Source of Frequency Command 040D 41038 2015
P4.14**
2nd Frequency Command Offset Polarity 040E 41039 2016
P4.15**
2nd Frequency Command Offset 040F 41040 2017
P4.16**
2nd Frequency Command Gain 0410 41041 2020
P4.17**
Trim Frequency Reference 0411 41042 2021
P4.18**
Trim Mode Select 0412 41043 2022
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...