4–13
Parameter Summary (continued)
Parameter
*
Description Range*
Default
Setting
User
Setting
Communications Parameters (continued)
P9.11
Block Transfer Parameter 1 P0.00 to P8.02, P9.99 P9.99
P9.12
Block Transfer Parameter 2 P0.00 to P8.02, P9.99 P9.99
P9.13
Block Transfer Parameter 3 P0.00 to P8.02, P9.99 P9.99
P9.14
Block Transfer Parameter 4 P0.00 to P8.02, P9.99 P9.99
P9.15
Block Transfer Parameter 5 P0.00 to P8.02, P9.99 P9.99
P9.16
Block Transfer Parameter 6 P0.00 to P8.02, P9.99 P9.99
P9.17
Block Transfer Parameter 7 P0.00 to P8.02, P9.99 P9.99
P9.18
Block Transfer Parameter 8 P0.00 to P8.02, P9.99 P9.99
P9.19
Block Transfer Parameter 9 P0.00 to P8.02, P9.99 P9.99
P9.20
Block Transfer Parameter 10 P0.00 to P8.02, P9.99 P9.99
P9.21
Block Transfer Parameter 11 P0.00 to P8.02, P9.99 P9.99
P9.22
Block Transfer Parameter 12 P0.00 to P8.02, P9.99 P9.99
P9.23
Block Transfer Parameter 13 P0.00 to P8.02, P9.99 P9.99
P9.24
Block Transfer Parameter 14 P0.00 to P8.02, P9.99 P9.99
P9.25
Block Transfer Parameter 15 P0.00 to P8.02, P9.99 P9.99
P9.26
Serial Comm Speed Reference 0.0 to 400.0 Hz 60.0
P9.27
Serial Comm RUN Command
00: Stop
01: Run
00
P9.28
Serial Comm Direction
Command
00: Forward
01: Reverse
00
P9.29
Serial Comm External Fault
00: No fault
01: External fault
00
P9.30
Serial Comm Fault Reset
00: No action
01: Fault Reset
00
P9.31
Serial Comm JOG Command
00: Stop
01: Jog
00
P9.39
Firmware Version #.## #.##
P9.40
Parameter Copy
00: Disable Copy Keypad Function
01: Enable Copy Keypad Function
00
P9.41
GS Series Number
01: GS1
02: GS2
03: GS3
04: GS4
##
* Some parameters and settings are available only in later firmware versions of DURAPULSE drives. Refer to
the beginning of this “DURA
PULSE Parameter Summary” section for more information.
Parameter can be set during RUN Mode.
Chapter 4: AC Drive Parameters
DURAPULSE AC Drive User Manual
1st Ed. Rev. D 05/2013
To Next Page
Loading...