Autonics LE4S Series User Manual

N-33
SENSORS
CONTROLLERS
MOTION DEVICES
SOFTWARE
(J)
Temperature
Controllers
(K)
SSRs
(L)
Power
Controllers
(M)
Counters
(N)
Timers
(O)
Digital
Panel Meters
(P)
Indicators
(Q)
Converters
(R)
Digital
Display Units
(S)
Sensor
Controllers
(T)
Switching
Mode Power
Supplies
(U)
Recorders
(V)
HMIs
(W)
Panel PC
(X)
Field Network
Devices
LCD Display Timer
● Output operation mode: FK, FK I
● Output operation mode: ON OFF D, ON OFF D I (LE4S only)
● Output operation mode: - , T, TI (LE4SA only)
※
It is able to change the setting time during the time progressing, but be sure about the time progressing while changing
of the time.
※
If pressing while setting time is shorter than min. setting time, setting value will be ickering three times and it will be
returned to setting mode again, not to RUN mode.
※
If there is no additional key operations in 60 sec after entering into setting mode, it will be return to RUN mode.
(set value is not stored.)
※
Min. setting time: 0.01 sec
(in case of:
OND
,
ONd1
,
ONd2
modes, it is able to set "0" since no min. setting time is applied.)
Run
mode
Run
mode
Run
mode
Run
mode
Setting
the time
Setting
the time
Setting
the time
Setting
the time
Setting of
OFfD
time
Setting of
OnD
time
Setting of
T-1
time
Setting of
T-2
time
Run
mode
Run
mode
Setting
the time
Setting
the time
Setting of
tOFF
time
Setting of
tON
time

Autonics LE4S Series Specifications

General

Brand	Autonics
Model	LE4S Series
Category	Timer
Language	English