Autool BT360 User Manual

AUTOOL Autool BT360 Battery System Tester
2
it can find out whether the starting motor works fine. There are several reasons
why the starting motor is abnormal: lubricating system fault causing the
starting loaded torque increasing or rotor friction of the starting motor causing
the increasing friction of the starting motor itself.
Charging test is to check and analyze the charging system, including
generator, rectifier, rectifier diode, etc., thus to find out whether the output
voltage of the generator is normal, the rectifier diode works fine and the
charging current is normal. Suppose one of the above mentioned parts is not
in normal situation, it will lead to over charge or incomplete charge of the
battery, thus the battery will be quickly damaged and also greatly shorten the
using life of other loaded electrical appliance.
Additional functions include: Set language, voltmeter and screen brightness
adjustment.
1.3 Technical Parameters
1. Cold Cranking Amps Measure Range:
Measure Standard Measure Range
CCA 100-2400
JIS 26A17--245H52
DIN 100-2200
IEC 100-2200
EN 100-2400
SAE 100-2400
GB 30-220Ah
BCI 100-2400
MCA 100-2400
CA 100-2400
2. Voltage Measure Range: 6.5-30VDC.

Autool BT360 Specifications

General

Brand	Autool
Model	BT360
Category	Test Equipment
Language	English